Shearing machine operating procedures
1, shearing machine should be someone responsible for the use and custody. The operator must be familiar with the structure and performance of the machine.
2, is strictly prohibited overloading shears. Shall not shear hardened steel and hard steel, high speed steel, alloy steel, castings and non-metallic materials.
3, blade edge should be kept sharp, blade blunt or damaged, should be repaired or replaced in a timely manner.
4, multi-person operation should be hand command, with the coordination.
5, shears on the machine at the same time cut two different specifications of the material, are not allowed to overlap shear.
6, cutting plate into the material when the handle is prohibited into the pressure plate below the operation. Cut short material should be used to suppress the other iron, cut the material when the fingers leave the blade at least 200 mm.
7, with the pry holding the line, you should immediately pull out of the pry out before cutting, such as iron have to move around, the application of wood pillow plug in order to avoid pressing the foot down after the pry holding the pop-up wounding.
8, cut the workpiece must be placed smooth, do not stack too high, are not allowed to pile up on the aisle. Corners and waste materials to clean up in time to keep the site clean and tidy.